FREE Shipping on Orders 49+ Use Coupon Code FREESHIP22
Excludes Alaska, Hawaii & Puerto Rico. Some exceptions may apply.
Add an extra layer in between your cutting plates by using the Plastic Shim for the Gemini Pro.
At 12” x 12” this has been designed to fit the Gemini Pro perfectly, so you can supersize your die cutting and embossing potential!
Shims are used in die-cutting to make the cutting-plate-die-paper-cutting-plate sandwich a little bit thicker. This helps to get an even more precise cut from your dies, especially if they are highly detailed or thin.
To care for your shim, please flip and rotate after each pass. If the shim does start to bow, flip over and pass through until it is flat again, then continue to flip and rotate as normal.